1.
the Personal Area Network HOWTO
Normally (unless you connect your PAN to a complex network) you should make these 2 calls. .... [2] "Personal Area Networking Profile", Revision 0.95a, ...
2.
HowTo set up common PAN scenarios with BlueZ's
The GN must be able to run as Bluetooth master (see above). .... NAP The instructions just given on how to set up a Group ad-hoc Network (GN) apply ...
3.
The Linux Bluetooth PAN Howto
configure # make # make install Before building, make sure you have the right Linux kernel version: BlueZ-PAN 1.0 requires either a kernel out of the 2.2 ...
4.
The Linux Bluetooth PAN Howto
BlueZ-PAN 1.0 is built just like any other BlueZ package: # ./configure # make # make install Before building, make sure you have the right Linux kernel ...
5.
The Linux Bluetooth PAN Howto
Alternatively, you can make a BlueZ PAN node BT master with: # pand --master Now ... The Linux "hotplug" mechanism that claims responsible for IP address ...
6.
HowTo set up common PAN scenarios with BlueZ's integrated PAN ...
Interfaces During connection establishment (this may take a few seconds), a virtual network interface 'bnep0' is created on both nodes. ...
7.
The Linux Bluetooth PAN Howto
So what happens is that the PAN daemon 'pand' calls a script named 'dev-up' in /etc/bluetooth/pan/ whenever a 'bnepx' interface has been created. ...
8.
HowTo set up common PAN scenarios with BlueZ's
The GN must be able to run as Bluetooth master (see above). .... NAP The instructions just given on how to set up a Group ad-hoc Network (GN) apply ...
9.
HowTo set up common PAN scenarios with BlueZ's
The GN must be able to run as Bluetooth master (see above). .... NAP The instructions just given on how to set up a Group ad-hoc Network (GN) apply ...
10.
HowTo set up common PAN scenarios with BlueZ's
The GN must be able to run as Bluetooth master (see above). .... NAP The instructions just given on how to set up a Group ad-hoc Network (GN) apply ...
